PolyPDF 1.2.0

Version 1.2.0 (build 9) · Requires macOS 14 or later · Apple silicon and Intel

Important: Perimeter measurements were low

Perimeter measured the sides you drew but never added the closing side — a 100 × 100 slab reported 300 instead of 400. It now closes the figure, and exports the same number it displays.

Saved measurements are not rewritten. If you have takeoffs that used Perimeter, re-check them.

New

Workspaces group markups by area of a drawing. Draw one around a wing, floor or phase and every markup inside it is counted there. Workspaces are a column in the Markup Table, so you can filter and total by area, and you can add an area markup straight to one by right-clicking it.
Scale regions let one sheet carry more than one drawing scale — a detail or blowup measures at its own scale rather than the page's. Pick from 28 architectural, engineering and metric presets, each carrying its own unit. A measurement that crosses a boundary asks which scale applies instead of guessing.
Path Length measures an open run — conduit, baseboard, curb. This is what Perimeter used to do by accident.

Fixed

Escape and Tab no longer get stuck in the Markup Table's column filter or in dialogs.
Arrow keys no longer nudge a selected region while you're navigating the sidebar.
Bookmarks can be traversed by keyboard through long documents.
The Estimate card and its dropdown labels fit the sidebar instead of being cut off.
Imported annotations keep their own appearance when PolyPDF's defaults change.
Selection handles and the default markup red are easier to see.